DeVilbiss SRi Pro Serie Manual De Instrucciones página 13

PARTS REPLACEMENT/MAINTENANCE
CHART 1 – AIR CAPS
AIR CAP & RING
COMPUTER NO.
803296 SRIPRO-101-HS1
803297 SRIPRO-100-TS1
NOTE: When removing air cap from retaining ring, don't remove the Slip Ring (2) or Retaining Ring Seal (5) from the
Retaining Ring . Damage to the parts may occur . Slip ring and Retaining Ring seal are not available as replacements .
Simply wipe parts clean and reassemble with new or clean air cap .
CHART 2 – FLUID NOZZLE RANGE & FLUID NEEDLE
FLUID NOZZLE
COMPUTER NO.
803298*
803299*
803300*
*Includes (1) SRIPRO-2 separator
NOTE: When replacing the fluid nozzle or fluid needle, replace both at the same time . Torque to 80-90 in-lbs (9-10 Nm) .
Don't over tighten the fluid nozzle . Use SRI-50 (6mm) wrench supplied with the gun and check with a torque wrench .
IMPORTANT NOTE: The SRI PRO and old SRI fluid nozzles and aircaps ARE NOT INTERCHANGEABLE between the
2 models. Any attempt to fit fluid nozzles or caps onto the wrong Spray Gun may cause damage to the parts or the
Spraygun body and invalidate the warranty.
TECHNOLOGY
PART NO.
HVLP
TRANS-TECH
PART NO.
SRIPRO-200-08-K*
SRIPRO-200-10-K*
SRIPRO-200-12-K*
MARKING RECOMMENDED
ON INLET
AIR CAP PRESSURE
HS1 29 .0 psi (2 .0 bar)
® TS1 29 .0 psi (2 .0 bar)
FLUID NEEDLE
COMPUTER NO.
803302
803303
SB-2-855-B Page 13
AIR FLOW
(L/min) (CFM)
135 4 .8
100 3 .5
PART NO.
SRIPRO-300-0810-K
SRIPRO-300-1214-K