Operation; Start-Up And Normal Operation; Operation On Battery Power; Low-Battery Warning - Eaton Pulsar Serie Manual De Instalación Y Usuario

3.1 Start-up and normal operation

For the initial start, AC input power must be present to detect any wiring errors. Subsequently, the UPS can start even
if AC input power is not present.
ESC
UPS personalisation
If UPS personalisation is desired, it is advised to enter the personalisation mode at this time.
This mode may be entered using the buttons on the control panel or the Personal Solution-Pac software (Windows)
included on the Solution-Pac CD-ROM provided by EATON.

3.2 Operation on battery power

Transfer to battery power
ESC

Low-battery warning

ESC
Press button (27) for approximately 1 second.
20
The buzzer beeps once and all the LEDs go ON simultaneously.
21
The buzzer then beeps twice during the self-test, then button (27)
22
remains ON, indicating that the load outputs are supplied.
The connected devices are protected by the UPS.
LED (20) is ON.
If LED (22) is ON, a fault has occurred (see the
section).
25
During normal operation, the scroll button (25) may be used to read
UPS measurements (voltage on normal and bypass AC inputs,
27
operating mode, battery capacity and UPS serial number).
The connected devices continue to be supplied by the UPS when AC
20
input power is no longer available. The necessary energy is provided
21
by the battery.
LEDs (20) and (21) go ON.
The audio alarm beeps every ten seconds.
The connected devices are supplied by the battery.
The display indicates the remaining backup time.
LEDs (20) and (21) go ON.
20
The audio alarm beeps every three seconds.
21
The remaining battery power is low.
Shut down all applications on the connected equipment because
automatic UPS shutdown is imminent.

3. Operation

" "
Troubleshooting
- Page 13
34007776EN/AD