SOMFY Sunea Screen 40 io Manual De Instrucciones página 28

EN
2.3.6. "Back impulse" function
This function is used to tension the fabric each time a er the awning has been
lowered. It can be adjusted up to ½ turn of the roller tube.
To activate this function:
Position the motorised product at the lower end limit.
1)
Press my and Λ at the same time until the motorised product moves up and down:
2)
the drive is in programming mode.
Adjust the tension of the fabric using the Λ and V buttons (max. ½ turn of the
3)
tube.).
Press my until the motorised product moves up and down: the fabric tension has
4)
been programmed.
2.3.7. "Back release" function
This function releases the fabric tension a er closing an awning with upper stop (load bar stopped under the head rail).
The procedure to follow to activate or deactivate "Back release" is identical.
For safety reasons, this function can only be activated or deactivated via the Somfy io-homecontrol
• A er the 2-second settings validation stop and before programming the first Somfy io-homecontrol
• A er programming the first Somfy io-homecontrol
• A er a single power cut, and for the next 4 cycles.
To activate this function:
Position the motorised product at the upper end limit.
1)
Press my and V at the same time until the motorised product moves up and
2)
down.
If the "Back release" function was inactive, it is activated.
If the "Back release" function was active, it is deactivated.
2.3.8. "Closing force" function
This function can be used to increase or decrease the load bar's force under the head rail, with 3 thresholds (high-medium-low).
The drive is factory set at the low level.
For safety reasons, this function can only be accessed via the Somfy io-homecontrol
• A er the 2-second settings validation stop and before programming the first Somfy io-homecontrol
• A er programming the first Somfy io-homecontrol
• A er a single power cut, and for the next 4 cycles.
To activate this function:
Put the motorised product in the middle position.
1)
Briefly press the my and Λ buttons at the same time, then immediately press
2)
and hold the my and Λ buttons at the same time until the motorised product
moves up and down.
The drive is in programming mode for just 10 seconds.
Adjust the closing force using the Λ and V buttons.
3)
To increase the closing force, press the Λ until the motorised product slowly
moves: the cassette awning closing force is increased to the upper threshold.
To reduce the closing force, press the V until the motorised product slowly moves: the cassette awning closing force is decreased to
the lower threshold.
Press my until the motorised product moves up and down: the new closing force has been programmed.
4)
28
control point and for the next 4 cycles.
®
control point and for the next 4 cycles.
®
Images not contractually binding
1) 2)
3) 4)
control point in 3 scenarios:
®
control point.
®
1)
2)
control point in 3 scenarios:
®
control point.
®
1) 2)
3) 4)
Copyright © 2016 Somfy SAS. All rights reserved.
0.5 s 5 s