Before Initial Start-Up; Engine Oil; Oil Considerations; Battery Connection - Briggs & Stratton 01917 Manual Del Usuario

BrJ_s & Stratton
Power Products Home Generator lV;_L') _)_'_I:} 1 _'4111
Owners Manual
BEFORE INITIAL START-UP
Engine Oil
This engine is shipped from the factory filled with the
recommended oil. Before starting the engine, check oil level
and ensure that engine is serviced as described in the
engine owner's manual.
CAUTION
• Refer to engine manual for oil fill information.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
Oil Considerations
Your Home Standby Generator is equipped with an engine
that has been pre-run at the factory and does not require
the traditional "break-in" procedure.
The system is filled with synthetic oil (API SJ/CF 5W-30W).
This allows for system operation in the widest range of
temperature and climate conditions.
NOTE: The use of synthetic oil DOES NOT alter the
required oil change intervals described in the engine
owner's manual.
Battery Connection
The Home Standby Generator is supplied with a 12Volt
DC 33 Amp-Hour battery. It is a sealed, lead-acid
rechargeable battery. It is installed in the unit and the
battery cables are connected at the factory.The unit's
15 Amp fuse, which isolates the battery and prevents the
unit from starting, has been removed for shipping.
t CAUTION
DO NOT install the 15Amp fuse until all plumbing and wiring
has been completed and inspected.
NOTE: With the battery installed, all wiring to transfer
switch and Home Standby Generator completed, utility
power supplied to the Automatic Transfer Switch, and the
unit in AUTO mode, the battery receives a trickle charge
while the engine is not running.The trickle charger cannot
be used to recharge a battery that is completely
discharged.
Gaseous Fuel System
• Ensure that all fuel connections are tight, secure and
without leaks.
, WARNING
DO NOT operate engine if smell of fuel is present or other
explosive conditions exist.
If you smell 'raw' gaseous fuel (natural or LP) near the unit,
immediately turn off the gas supply to the Home Standby
Generator.
Contact your gas utility or the system installer for assistance
in determining the source of the smell.
Ensure that all shutoff valves are OPEN and that
adequate
pressure is available
(see installation manual).
12