Cleaning And Maintenance; Technical Data - AEG SR 4367 BT Instrucciones De Servicio

1. Press the button to switch the device to standby.
2. Press and hold the SLEEP/TIMER button (7 on the remote
control) for approx. 3 seconds. " " and "ON TIMER"
will flash in the display. Press the SLEEP/TIMER button
to confirm. After that, the hour digits of the current clock
time will flash.
3. Use the and buttons to adjust the settings accord-
ingly.
4. Press the SLEEP/TIMER button to confirm. The minutes
start flashing.
5. Use the and buttons to adjust the settings accord-
ingly.
6. Press the SLEEP/TIMER button to confirm. Then use the
FUNC button to select the alarm mode: TUNER, USB or
CARD.
7. Press the SLEEP/TIMER button to confirm.
8. Then use the VOLUME / buttons to adjust the volume
for the alarm function.
NOTE:
• Select a lower volume setting. We recommond
level "03" or level "04".
• Please note that there will be no alarm when select-
ing level "00".
9. Finally, press the SLEEP/TIMER button. The timer is then
set. "ON" will briefly appear in the display. After that,
" " and the current clock time will be displayed.
Turning off the alarm
To turn off the alarm until the following day, press the
button.
Deactivating the alarm function (in standby mode)
Press the SLEEP/TIMER button. "OFF" will briefly appear in
the display and the " " icon will disappear.
Delayed switch-off
Do you like to fall asleep with music?
1. Turn on the device with the desired mode.
2. Press the SLEEP/TIMER button (7 on the remote control).
The minute setting "90" appears in the display and "
will flash.
3. Reduce the time in increments of 10 minutes by pressing
the SLEEP/TIMER button.
4. Once you have adjusted the timer as desired, "
be lit constantly.
• Selecting "OFF" will deactivate this function.
NOTE:
Pressing the SLEEP/TIMER button briefly will display the
remaining time left until standby is activated.

Cleaning and Maintenance

WARNING!
Do not immerse the device in water.
• Always remove the mains plug before cleaning the
machine.
• Any marks on the surface can be wiped off with a slightly
damp cloth without any additives.
Troubleshooting
Symptoms Course
No music Batteries too weak. Insert new batteries
playback.
Device cannot Device crashes and
be operated. "hangs".
No audio signal The device is not
during blue- registered with the
tooth connec- audio source.
tion.
Volume too low.
Device can not Registration does
be connected. not work.
Audio source is
shut off.
Bluetooth is shut
off on the audio
source.
Bluetooth version
is not supported.
"

Technical Data

Model: ............................................................................. SR 4367 BT
Battery operation: ........................................ 8 x 1.5 V, Type D/R20
" will
Power consumption:.................................................................30 W
Protection class: ...............................................................................III
Protection rating: ........................................................................ IP44
Net weight: ................................................................approx. 3.8 kg
Radio section:
Frequency ranges: ...............................FM 87.5 ~ 108.0 MHz
English
51
Solution
or operate the device
with the mains lead.
Disconnect the power
supply for 5 sec. Then
switch the device on
again.
Ensure that there is a
connection. Register
the device with the
audio source again, if
necessary.
Increase the volume
on the device.
Increase the volume
on the audio source.
Check to see if the
audio source supports
the A2DP protocol.
Turn on the audio
source.
Turn on the Bluetooth
function on the audio
source.
Use a different play-
back device.