Tabla de contenido
Idiomas disponibles
Idiomas disponibles
b. Installing of monitor (
fig.4)
Install the monitor at approximately 1,60 m above the ground (for optimum reception conditions).
For installing the monitor, choose a location away from reinforced concrete walls, mirrors, metallic shelves, etc...
Keep the monitor away from all appliances creating strong electrical interference.
Any strong electrical environment may cause disturbances and interferes with the use (WIFI in particular).
For table-mounting, unfold the foot (A) and install the monitor on a stable surface.
Connecting the monitor:
1. Connect the cord of the 5 V
adaptor to the "power supply" plug of the monitor. (B)
2. Plug the adaptor into a 230 V mains socket.
Warning :
Only place the monitor on stable and hard surfaces.
5. DIRECTIONS FOR USE
The monitor must be in standby mode, the indicator
Call button is pressed on the roadside panel the monitor will ring for approximately 8 seconds. At the same time,
a tone will sound on the roadside panel to confirm that the call has been sent. You have approximately 30 seconds
to answer the call. At this time, the electronic box enters standby mode. If the electronic cabinet is powered by a
12 or 24 V /
source, you can force the communication with the roadside panel pressing the
tronic cabinet is battery-powered the call is lost.
The conversation is established during a call pressing the
the key
The system will time out after 30 seconds. To extend this time for an additional 30 seconds, press the Answer
buttons
or
during a call. You can end the communication pressing
1• Recording from the monitor: (SD card required) :
- If the "visiting record" option (see b.p.7) is not activated, recording can be started/stopped by pressing on
- If the "visiting record" option is activated, recording starts automatically when a call is made from the intercom
panel.
2 • If used with an electric strike plate (or electric lock) :
The electric strike plate can be opened only when communicating with a caller(all the time if the electronic cabi-
net is powered by external AC/DC supply), To open it, press briefly the
Caution :
One single opening control is possible per call under operation on battery.
N.B.:
The strike plate or lock must be «one pulse type» in order for the door/gate to be opened.
3• If used with an automatic opener :
: An automatic gate opener may be operated via remote control If the electronic cabinet is powered by
Caution
external AC/DC supply. To open it, press the key
- If no call is in progress, press on
then on
Reminder
:The reception of a call on the monitor is only possible if it is in standby mode and paired with the
roadside panel (see chapter Pairing).
Important :
The handset has a free-field range of up to approximately 300 metres. This range may be considerably
reduced by certain environmental factors (nearby radio interference, etc.)
CFI EXTEL WEVA - 11/2011
GB5
turned blue. (this mode is activated with
). When the
key. If the elec-
and
key. You can increase the volume by pressing
or
for 3 seconds.
key , then press briefly the
for 3 seconds during a call.
for 3 seconds.
6. SCREEN ICON
a. Signal indicator
b. Visiting record indicator (On)
c. Outdoor unit battery indicator
- Full Battery (yellow)
- Low Battery (red/twinkling)
d. Manual recording
e.
: no SD card
F : Full SD card
Err. : SD card error
: SD card locked
: SD card overwrite
f. SD card indicator
g. SD card storage room indicator
h. No signal indicator
i. Answering indicator
j. Record time
k. System time
7. MENU
Press ESC key for 2 seconds to display the following screens (
.
(1 sec.).
a. Camera Setup
c. Event List
and
to scroll, OK to validate).
b. Recorder Setup
d. System Setup
CFI EXTEL WEVA - 11/2011
GB6
Capítulos
Tabla de contenido
