Guided Tour - Sr5 Front Panel - Samson Stage 55 Manual De Instrucciones

Guided Tour - SR5 Front Panel

1
3
4
2 5 7
1: Antenna - The antenna mounting allows full rotation for optimum placement. In normal
operation, the antenna should be placed in a vertical position. It also can be folded inward for
convenience when transporting the SR5. See the "Setting Up and Using Your Stage 55 Series /
Stage 5 Series System" section on page 12 in this manual for more information about antenna
positioning.
2: Volume control - This knob sets the level of the audio signal being output through both the
balanced and unbalanced output jacks on the rear panel. Reference level is obtained when the
knob is turned fully clockwise.
3: Audio Meter - This "ladder" display (similar to the VU bar meter used on audio devices) indi-
cates the strength of the incoming audio signal. When the "0" segment is lit, the incoming signal
is optimized at unity gain; when the "+6" segment is lit, the signal is overloading. When only the
left-most "-20" segment is lit, the incoming signal is at just 10% of optimum strength. If no seg-
ments are lit, little or no signal is being received. See the "Setting Up and Using Your Stage 55
Series / Stage 5 Series System" section on page 12 in this manual for more information.
4: Squelch control - This control determines the maximum range of the SR5 before audio signal
dropout. Although it can be adjusted using the supplied plastic screwdriver, it should normally
be left at its factory setting. See the "Setting Up and Using Your Stage 55 Series / Stage 5 Series
System" section on page 12 in this manual for more information.
5: "TX" LED - Lights when carrier signal of sufficient strength is being received by the SR5.
6: RF Meter - This "ladder" display (similar to the VU bar meter used on audio devices) indicates
the strength of the incoming radio signal. When the "100%" segment is lit, the incoming RF signal
is fully modulated and at optimum strength. When only the second most left-most "10%" seg-
ment is lit, the incoming signal is at just 10% of optimum strength. If no segments are lit, little or
no signal is being received. See the "Setting Up and Using Your Stage 55 Series / Stage 5 Series
System" section on page 12 in this manual for more information.
7: Power switch - Use this to turn the SR5 power on and off.
5