Seca 869 Manual De Instrucciones página 22

– To switch off the scale, press the Start
key again.
5. Cleaning
Clean the rubber surface and the housing as required using a domestic cleaning agent or
commercially-available disinfectant. Follow the manufacturer's instructions.
Under no circumstances use abrasive or acid cleaners, white spirit, benzene or the like for
cleaning. Such substances can damage the high-quality surfaces and the printing.
6. What do I do if...
... no weight display comes on?
– Is the scale switched on?
– Check the batteries.
– Is the plug contact for connecting the display to the scale correctly connected?
– Is the plug contact of the mains unit properly connected to the scale?
0. 0
... does not appear before weighing?
– Switch off the scale with the Start key and start the scale again – there must not be any load
on the scale – and only its feet should be in contact with the floor.
... one segment is illuminated constantly or not at all?
– The relevant segment has a fault. Inform Servicing.
... the display shows
– Battery voltage is running low. Change the batteries in the next few days.
bAtt
... appears in the display?
– Batteries are empty. Put in new batteries.
St0p
... appears in the display?
– Maximum load has been exceeded.
... the display flashes?
– If you have just activated the Hold or Tare function, please wait until the scale has detected a
steady weight value. The display will then stop flashing.
– If there has been no activation of a function beforehand, remove the load from the scale and
0. 0
wait until is displayed, then weigh again.
E
... the display and XX.XX appear?
– Switch off the scale with the Start key and start the scale again. The scale will then work nor-
mally again.
If this is not the case, disconnect the power supply by briefly removing the batteries. If this
measure is equally unsuccessful, inform the Service department.
22
?