Battery And Battery Charger; Battery Charging - Bosch PSB 12 VE-2 Instrucciones De Servicio

For Your Safety
Working safely with this ma-
chine is possible only when the
operating and safety information
are read completely and the in-
structions contained therein are
strictly followed. In addition, the
general safety notes in the enclosed booklet
must be observed.
Wear safety goggles.
For long hair, wear hair protection. Work only
with closely fitting clothes.
Before each use, check the machine and bat-
tery. If damage is detected, do not use the ma-
chine. Have repairs performed only by a qual-
ified technician. Never open the machine your-
self.
Before any work on the machine itself (e. g.
maintenance, tool change, etc.) as well as
when transporting and storing, always set
the rotational direction switch to the centre
position. Otherwise danger of injury is given
when unintentionally actuating the On /Off
switch.
Convince yourself before using that the battery
is securely seated in the machine.
Do not strain the machine so heavily that it
comes to a standstill.
PSB 18 VE-2/PSB 24 VE-2: Operate the ma-
chine only with the auxiliary handle 4.
When working with the machine, always hold it
firmly with both hands and provide for a secure
stance.
Use appropriate detectors to determine if
utility lines are hidden in the work area or
call the local utility company for assist-
ance.
Contact with electric lines can lead to fire and
electric shock. Damaging a gas line can lead
to explosion. Penetrating a water line causes
property damage.
Hold the power tool securely: When tightening
or releasing screws, high reaction torque can
briefly occur.
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held more
secure than by hand.
Never allow children to use the machine.
Bosch is only able to ensure perfect operation
of the machine if the original accessories in-
tended for it are used.
10 • 2 609 932 336 • TMS • 26.01.04

Battery and Battery Charger

The enclosed operating instructions for the
battery charger must be read carefully!
Do not open the battery, and protect it from im-
pact. Store in a dry and frost-free place.
Allow a heated battery to cool before charging.
Protect the battery from heat and fire: Danger
of explosion!
Do not dispose of the battery in household
waste or discard into fire or water.
Before Putting into Operation

Battery Charging

A battery that is new or has not been used for a
longer period does not develop its full capacity
until after approximately 5 charging /discharging
cycles.
To remove the battery 5, press the unlocking but-
tons 10 and pull out the battery to the rear. Do not
exert any force.
The battery is equipped with an NTC temperature
control which allows charging only within a tem-
perature range of between 0 °C and 45 °C.
A long battery service life is achieved in this man-
ner.
A significantly reduced working period after
charging indicates that the batteries are used and
must be replaced.
Observe the notes on environmental protec-
tion.
Auxiliary Handle (see figure
(PSB 18 VE-2/PSB 24 VE-2)
Operate the machine only with the auxiliary
handle 4.
Screw the auxiliary handle 4 on the right or left of
the machine head depending on the working
method.
English - 2
)
A