Anselmo Cola TOPFIRE 80 Manual De Instalación, Uso Y Mantenimiento página 58

Brazier dirty
5.2 Cleaning the ash container
The ash container is located directly under the brazier - brazier holder. To clean it, open the fire door and remove
the ash and any combustion residuals using a suitable vacuum cleaner.
The door must be closed after cleaning. The ash container can be cleaned every 2-3 days depending on insert use.
5.3 Cleaning the glass and air slots
The glass can be cleaned using a damp cloth and specific non-abrasive detergents.
Special slots between the glass, glass stops and fire door at the top and bottom allow air to circulate and cleaning of
the inside surface of the glass. These slots must be kept clean of any deposits of ash and dust. Therefore
periodically clean all around the inner side of the glass.
5.4 Cleaning the fume extractor and combustion chamber
The combustion chamber must be cleaned at least once a year, removing all combustion residuals from the internal
baffles and flueways. To do this, pull the insert out and remove the covers and the top grille. Remove the cast iron
exchanger by undoing the fixing screws then clean the baffles and the chamber.
It is also important to clean the fume extractor located at the side behind the chamber and the fume manifold which
is accessed by removing the inspection doors behind the ash pan on the bottom of the chamber.
Inspection
doors
Every 3-4 months clean the inside walls (insulating-refractory) of the combustion chamber using suitable
equipment (brushes) and replace them if necessary.
Every 1800 hours of operation, by means of a message 'SERVICE DUE' the insert signals the need for
extraordinary maintenance (not under warranty), to be performed by qualified personnel who will carry out complete
cleaning and reset the message.
Any knocking or forcing can damage the fume extractor, making it noisy during
operation; therefore it is advisable to have this operation carried out by qualified personnel.
5.5 Cleaning the air flow meter
The air flow meter (it measures the flow of combustion air) installed inside the inlet pipe requires periodical internal
cleaning every 3-4 months, using suitable equipment (blowing compressed air or suitable brushes).
Brazier clean Brazier Holder clean
The brazier must rest on the
brazier holder and precisely on the
entire ring band without air gaps.
58 TOPFIRE 80 canalizzabile