Troubleshooting - Schneider Airsystems SBS 700 SYS Manual De Instrucciones

GB
SLM
2.9

Troubleshooting

Observe the safety instructions and maintenance instructions!
Problem
A Minimum or no
operating capacity
*For troubleshooting: refer to the information in the "Technical data" chapter in part 1 of the instruction manual!
**See Chapter: "Intended use" in Instruction manual part 1!
***For troubleshooting: read chapter: "Commissioning"!
****For troubleshooting: read chapter: "Maintenance"!
If necessary, contact our service staff, see last page.
II/ 10
Cause
Air regulation (item 03) set-
ting incorrect
Abrasive / Tool worn
Working pressure (flow pres-
sure) too low
Compressor output too small
Hose diameter too small
Remedy
Adjust the air regulation setting
***
correctly
Replace abrasive / tool
Increase working pressure (flow
pressure) Observe
working pressure
Use different output
*
rating
Use correct hose diameter
*
maximum
*
*