Tabla de contenido
Idiomas disponibles
Idiomas disponibles
lever returns to RUN position).
Steps 5 and 6 are not necessary.
5.
Fully squeeze the throttle trigger to
disengage the starting system (start
lever returns to RUN position).
6.
Pull starter rope handle with a con-
trolled and steady motion while
squeezing
throttle trigger until
engine starts and runs.
STARTING
A WARM ENGINE
1. Squeeze
and hold the throttle trig-
ger.
2.
Pull starter rope handle with a con-
trolled and steady motion while
squeezing
throttle trigger until en-
gine starts and runs.
NOTE: Normally, the warm starting
procedure
can be used within 5-10
minutes
after the unit is turned off. If
the unit sits for more than 10 minutes
without
being used, it will be necessary
to start the unit by following
the steps
under STARTING A COLD ENGINE or fol-
lowing the starting instruction
steps
shown on the unit.
STARTING
A FLOODED
ENGINE
Flooded engines can be started by mov-
ing the start lever to the RUN position
and fully squeezing
the throttle trigger.
Pull the starter handle repeatedly
while
squeezing
throttle trigger until engine
starts and runs. This could require pull-
ing the starter handle many times, de-
pending on how badly the unit is
flooded.
If the unit still doesn't start, re-
fer to the TROUBLESHOOTING TABLE or
call 1-800-235-5878.
CUSTOMER
RESPONSIBILITIES
WARNING:
Disconnect
the spark plug before performing
maintenance,
service, or adjustments.
CARE & MAINTENANCE
TASK
Check for loose fasteners and parts
Check for damaged
or worn parts
Inspect and clean unit and labels
Clean air filter
Replace spark plug
Replace fuel filter
Check muffler mounting
screws
WHEN TO PERFORM
Before each use
Before each use
After each use
Every 5 hours of operation
Yearly
Yearly
Yearly
,_= WARNING:
Avoid touching
muf-
fler unless engine and muffler are cold.
A hot muffler can cause serious burns.
_,WARNING:
Stop engine and be
sure the impeller blades have stopped
turning before opening the vacuum
in-
let door or attempting
to insert or re-
move the vacuum
or blower tubes.
The rotating blades can cause serious
injury. Always disconnect
the spark
plug before performing
maintenance
or
accessing
movable
parts.
GENERAL
RECOMMEN
DATIONS
The warranty on this unit does not cov-
er items that have been subjected
to
operator
abuse or negligence.
To re-
ceive full value from the warranty, the
operator
must maintain
unit as instruct-
ed in this manual. Various adjustments
will need to be made periodically
to
properly
maintain your unit.
CHECK
FOR LOOSE
FASTENERS
AND PARTS
• Muffler
• Spark Plug Boot
• Air Filter
• Housing Screws
CHECK
FOR DAMAGED
OR
WORN
PARTS
Contact Sears Service Center for re-
placement
of damaged
or worn parts.
• Throttle Lever - Ensure throttle lever
functions
properly
by moving the
throttle lever to the STOP position.
Make sure engine stops; then restart
engine and continue.
• Fuel Tank - Do not use unit if fuel tank
shows signs of damage or leaks.
• Vacuum Bag - Do not use vacuum
bag if it is torn or damaged.
-11
-
Tabla de contenido
