Tabla de contenido
Idiomas disponibles
Idiomas disponibles
5. Fasten angle irons to roof structure mounting points
Fasten the angle irons to the roof structure mounting points at each end with Grade 8 hardware. Do not fully
tighten the hardware.
Single Angle Irons: Position the angle irons so that the horizontal legs face each other (vertical legs are on the
outside).
Double Angle Irons: Position the angle irons with fan mounting holes on the inside, facing each other.
Grade 8 Angle Iron Hardware (Installer-Supplied):
a. (4 or 8) 1/2-13 GR 8 Bolt
b. (8 or 16) 1/2" GR 8 Washer
Illustrator: add dotted lines here
c. (4 or 8) 2" x 3" (51 x 76 mm) Rectangular Washer (supplied; see diagram)
if this ends up being seen...
d. (4 or 8) 1/2-13 GR 8 Nylock Nut
Single Angle Irons
a
b
c
b
d
8
Illustrator: add dotted lines here
if this ends up being seen...
Rectangular Washer
Ø 9/16"
(14 mm)
DO NOT FULLY
TIGHTEN
Vertical legs are
on the outside
WWW.BIGASSFANS.COM
Illustrator: add dotted lines here
if this ends up being seen...
2" (51 mm)
3"
(76 mm)
Thickness:
0.15" (4 mm)
© 2018 DELTA T LLC
ALL RIGHTS RESERVED.
Illustrator: add dotted lines here
if this ends up being seen...
Double Angle Irons
a
b
c
b
d
Tabla de contenido
