Parameter Adjustment - EdilKamin ECOIDRO Guía De Instalación, Uso Y Mantenimiento

Switching off
Hold the 0/1 key down for two seconds while the stove is operating. The shutdown starts and the word Off appears on the
display (for 10 minutes).
During shutdown:
- Pellet loading ceases.
- Ventilation turns up to maximum.
- The water circulates.
Never unplug the stove while it is shutting down.
Clock adjustment
Hold the menu key down for two seconds to access the menu. The on-board clock operating parameters may be set from this
menu.
Weekly time programmer
Press the menu key for two seconds to access the time setting function and press + to access weekly time programming: the mes-
sage "timer on/off" appears on the display.
The stove may be programmed to come on and switch off automatically up to three times a day on each day of the week.
Confirm with the "menu" key while the display shows "timer On/off". One of the following messages appears:
NO PROGRAM (not programmed).
DAILY PROGRAM (programmed to do the same thing every day).
WEEKLY PROGRAM (programmed differently for each day).
You can go from one to another using the + and - keys.
Confirm the "DAILY PROGRAM" option with the menu key to choose the number of programs (on/off) per day.
If you confirm "DAILY PROGRAM", the program(s) set will be the same every day of the week.
After confirming "WEEKLY PROGRAM", choose the day the program applies to:
1 Mon, 2 Tue, 3 Wed, 4 Thu, 5 Fri, 6 Sat and 7 Sun.
Once the day has been selected using the + and - keys and confirmed with the menu key, continue in the same way as for the
"DAILY PROGRAM". Choose the number of programs and the times for each day of the week.
If you make a mistake while programming, you can exit by pressing the 0/1 key: the display shows "Saved".
Change pellet load
Press the menu key for two seconds and scroll through the items using the + and - keys until "adj.pellet" appears on the display.
Confirm this item by pressing the menu key. The pellet load setting appears. This function may be useful if the type of pellet the
stove has been calibrated for is changed, thus making load adjustment necessary.
If adjusting this setting is not sufficient, contact the Dealer for a new operating setup.
Cold test (I/O TEST)
This menu is only accessible when the stove is on standby. It is used to check the components.
It may only be accessed by the Dealer: a password is required.

Parameter adjustment

Press the menu key for two seconds and scroll through the items using the + and - keys until "setup" appears on the display. The
main stove parameters may be adjusted on this menu It may only be accessed by Dealer: a password is required.
33