Set-Up Of Kli 310/312 To Operate Velux Integra ® Blinds - Velux INTEGRA KLI 310 Instrucciones

1A
10 sec
2
3
max 3 sec
24 VELUX
®
1B
10 sec
1 sec
Set-up of KLI 310/312 to operate VELUX INTEGRA
Important: The wall switch must be the universal KLI 310 or the model
matching the product.
If a non-functional control must be replaced or if the wall switch cannot
find certain products, you can make the products ready for registration
by manually resetting them to initial factory settings.
Note: Reset products cannot be operated until they have been regis-
tered in the wall switch again.
Reset the blind.
The solar-powered blinds can have two different designs:
1A Solar-powered blind with sliding switch on the right, bottom side of
motor unit:
Slide switch to the right and hold for 10 seconds.
The blind will run briefly back and forth indicating that it is ready to
be registered.
1B Solar-powered blind with button behind door at the bottom of
motor unit:
Open solar battery door, press button behind the door for 10 sec-
onds and close solar battery door.
The blind will run briefly back and forth indicating that it is ready to
be registered.
Note: The blind must now be registered in the wall switch within the
next 10 minutes.
Press the Pair button on the wall switch for 1 second.
2
Press the stop key and then the DOWN key within 3 seconds. This is
3
only necessary at the initial set-up after installing the blind.
The blind can now be operated by KLI 310/312.
blinds
®
VELUX 25
®