SATA clean RCS Serie Instrucciones De Servicio página 103

Ex II 2 G T4
EX
II
2
G
T4
2.4. Safety instructions
Technical status
■ Check the functions of SATA clean RCS and check for any leaks every
time before they are used.
■ Never start using SATA clean RCS when damaged or when parts are
missing.
■ Check SATA clean RCS every time before use and repair if necessary.
■ Stop using SATA clean RCS immediately if they are damaged and dis-
connect from the compressed air circuit.
■ Never make any unauthorised modifications or technical changes to SATA
clean RCS.
Cleaning agents
■ Never use acidic or alkaline cleaning agents or cleaning agents containing
petrol.
■ Never use cleaning agents based on halogenated hydrocarbons.
Connected components
■ Only use original SATA spare parts and accessories.
■ The connected hoses and lines must reliably withstand the thermal,
chemical and mechanical loads expected when using SATA clean RCS.
■ When pressurised hoses work loose, their whip-like movements can
cause injuries. Always vent the hoses completely before they are loos-
ened.
Installation site
■ When installing SATA clean RCS outside the spray booth for operations
using cleaning solutions containing solvents, always comply with the
following:
■ Ex-zone 1 applies up to a radius of 3 m around the unit.
■ Ex-zone 2 applies in a range from 3 m to 5 m around the unit.
■ Never use SATA clean RCS in the vicinity of ignition sources, such
as naked flames, burning cigarettes or non-explosion-proof electrical
Operating Instructions SATA RCS
EX symbol
Equipment category
Device category
Gas category
Temperature category
EN
103