Fuse Check/Replacement - KENT Razor 20 Instrucciones De Uso

FUSE CHECK/REPLACEMENT

1. Disconnect the battery connector (12).
2. Move aside the recovery water drain hose (16).
3. If equipped, remove the battery charger cable (I, Fig. 7) from the holder (J).
4. Remove the screws (A) and carefully move aside the panel (B) by disengaging the grommet (K) from its housing on the panel
(B).
5. Check/replace the following fuses:
C) F1 fuse, deck: (40 A)
D) F2 fuse, vacuum system: (30 A)
E) F3 fuse, drive system: (30 A) (*)
F) F4 fuse, signal circuits: (3 A)
G) F5 fuse, brush/pad-holder release: (20 A)
H) F6 fuse, pump: (3 A)
(*) Only for RAZOR 20T
6. Perform steps 1 to 4 in the reverse order.
F G H
B
A
A
A
J
I
Figure 7
RAZOR 20 - RAZOR 20T
INSTRUCTIONS FOR USE
A
D
E
C
K
9097063000(1)2007-06
ENGLISH
P100144
21