Safety Instructions - Helvi EXPLORER 120 Manual De Uso

This manual contains safety and operating instructions.
Please read it carefully before using the device for the first time and keep it for future reference.
This machine should only be used for charging operations specified within the limits indicated
on the machine and in the instruction manual. The operator must observe the safety precau-
tions. In case of improper or unsafe use, the manufacturer cannot be held liable.
The device is destined to be used indoors. Must not be exposed to the rain.
This unit can be used by children aged 8 or over and by people with reduced physical, sensory
or mental capabilities or lack of experience or knowledge, if they are properly monitored or
if instructions for using the equipment have safely been read and potential risks understood.
Children must not play with the product. Cleaning and maintenance should not be performed
by an unsupervised child.
Do not use to charge domestic batteries or non rechargeable batteries.
Do not use the charger if the mains cable or plug is damaged.
Never use on a frozen or damaged battery.
Do not cover the device.
Do not place the unit near a heat source or expose to prolonged high temperatures (above
50 ° C).
The operating mode of the automatic charger and the restrictions applicable to its use are
explained later in this manual.
Fire and explosion risks!
• A battery can emit explosive gases when on charge.
• During the charge, the battery must be placed in a well ventilated area.
• Avoid flames and sparks.
• Protect the electrical contact surfaces of the battery against short circuits.
Risk of acid dispersion!
• Wear protective goggles and gloves.
• In case of contact with the eyes or the skin, rinse immediately with water and see a medical
doctor as soon as possible.
Connection / disconnection :
• Disconnect the power supply before plugging or unplugging the connections to/from the
battery.
• Always ensure the Red clamp is connected to the «+» battery terminal first. If it is necessary
to connect the black clamp to the vehicle chassis, make sure it is a safe distance from the
battery and the fuel line. The charger must be connected to the mains.
• After charging, disconnect the charger from the mains, then disconnect the negative clamp
from the car body and then disconnect the positive clamp from the battery, in this order.
Connection :
• The charger must be connected to an earthed power supply.
• The connection to the power supply must be carried out in compliance with national
standards.
Maintenance :
• If the power supply cable is damaged, the replacement cable must be obtained from the
manufacturer or its service team.
• Maintenance should only be carried out by a qualified person.
4

SAFETY INSTRUCTIONS