Connectivity Modules; List Of Error Codes - Helvi EXPLORER 120 Manual De Uso

Li-SUPPLY/LFP
Li-SUPPLY/Li-ion
MISCELLANEOUS
TESTER MODE
Predefined configurations adapted to each application. Contact the manufacturer or dealer (see the
nameplate).
Configuration file (120)
1_120_original.gfc Initial configuration of the charger
2_car_extended.gfc Extensive features for garages
Simplified version for dealerships and
3_showroom_only.gfc
demonstration vehicles
4_pro_lithium.gfc Professional of lithium battery
5_traction.gfc Forklift truck, electric pallet truck, stacker...
6_full_version.gfc Full version
Your Explorer 120 is equipped with a DB9 type socket allowing you to connect various additional modules
offered such as a printer, Ethernet or other module in order to further extend the possibilities of your charger.
Error code
Err01: Int_1-
1 Err02: Int_2
Err23 : Int_3
2 Err03: Fuse_NOK Output fuse out of order
3 Err04: T>Tmax
4 Err05: (+)(-)
5 Err06: U>__V
6 Err07: No_bat
7 Err08: U<__V
8 Err09: U>__V
9 Err10: U>2.0V
10 Err11: Time_Out
Mode intended to supply lithium-ion cells of the LFP type (Lithium Ferro Phosphate)
with selection of the number of cells in series, adjustment of the voltage and current
to be applied.
Mode intended to supply standard lithium-ion batteries based on Manganese or Cobalt
(NMC, LCO, LMO, MCO...) with selection of the number of cells in series, adjustment
of the voltage and current to be applied.
Allows to check the state of the battery, to evaluate the starting of the vehicle as well
as the operation of the alternator
Applications

CONNECTIVITY MODULES

LIST OF ERROR CODES

Meaning
Electronic problem
Defective charger
Abnormal overheating
The polarity has been
reversed on the clamps
Overvoltage detected at the
clamp terminals
Battery not connected
Abnormally low battery
voltage
Abnormally high battery
voltage
Short-circuit detected during
the charge process
Triggering the time limit
Abnormally long charge
CHARGE MODE
Pb-CHARGE Li-CHARGE
Solutions
Contact the reseller
Have the fuse replaced by a qualified person
Contact the reseller
Connect the red clamp to the (+) and the black
clamp to the (-) of the battery.
Disconnect the clamps
Check that the battery is correctly connected to the
charger
Check that the selected mode is compatible with the
battery voltage (e. g. : 6 V battery in 24 V mode)
Charge the battery via CHARGE mode
Battery to be replaced
Check that the selected mode is compatible with the
battery voltage (e. g. : 24 V battery in 12 V mode)
Check the assembly
Presence of a consumer on the battery disrupting
the charge
Battery to be replaced
POWER MODES
TRACTION
MISCELLANEOUS
13