Bottom Bobbin Placement - EASYHOME MS-201 Manual Del Usuario

Ocultar thumbs Ver también para MS-201:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

4. Bring thread over and across the Tension Adjusting Screw (3), positioning
thread between the 2 washers behind the tension adjusting screw. This is
what provides the lock stitch tension to the thread.
5. Pull thread from the Tension Adjusting Screw (3) guide through the 2
Guide (4) pulling thread from right to left.
6. Pull thread through the Take Up Lever (5) inserting thread from right to left.
7. Pull thread downward through 3
top down.
8. Pull thread downward through 4
9. Insert thread through eye of the Needle (8) from left to right, using the needle
threader if necessary. If needed, adjust the needle to reach the eye by turning
the hand wheel slightly clockwise (in the direction away from you).
Note: To use the needle threader, push the wire together and place needle
threader through the eye of the needle from right to left. Insert the thread
through the eye of the needle threader. Holding onto the needle threader
near the wire, pull the needle threader out of the needle, guiding the thread
through the eye of the needle.
10. Raise the Presser Foot by lifting up on the Presser Foot Lever located at the
back of the machine.
11. Pull about 5 inches of thread through the needle. Pull thread between the
presser foot and lay on the deck under the presser foot, running it in the
direction away from you.

Bottom bobbin placement

1. Remove Bobbin Compartment Cover (C) by sliding it straight out to the left.
2. Place the bobbin with thread of your choice in the Bobbin Compartment (B)
leaving about 5 inches of thread extended out from the bobbin holder and
place in the Thread Gap (A).
3. Note: The machine must be threaded before attempting to bring the thread
up from the bottom bobbin compartment.
4. Turn Hand Wheel (W) counterclockwise (towards you) until the needle has
descended completely and come up again to its highest raised point. Stop
rd
Thread Guide (6) and insert thread from the
th
Thread Guide (7).
User instructions
nd
Thread
13

Capítulos

Tabla de contenido
loading

Tabla de contenido