Snooze Function; Weather Forecast; Temperature And Humidity; Moon Phases - Bresser Explore Scientific LANGUAGE CODE 2 Manual De Instrucciones

SNOOZE FUNCTION

1. Press the [ SNZ / LIGHT ] button for about 3
seconds to enter the snooze time interval setting.
The preset digit flashes (03-20 minutes)
2. Press [ ▲/CF ] or [▼/RCC ] button to change
the value.
3. Finally, press the [ MODE ] button to save the
settings and exit settings mode.
4. At the set time, alarm signal rings.
5. During the alarm, press the [ SNZ / LIGHT ]
button to delay the alarm by the previously set
time interval.
6. To stop the alarm, press [ ALARM ] or any other
button, except for [ SNZ / LIGHT ].
7. The alarm will start again at the next alarm time,
unless you switch off the alarm function by
pressing the [ ALARM ] button until the alarm
is set to off.

WEATHER FORECAST

This device calculates a weather forecast for the
next 12 hours on basis of the measured values.
It has 6 kinds of dynamic weather forecast.
SYMBOL
6
DESCRIPTION
Sunny
Clear to
overcast
Cloudy
Rainy
Stormy
Snowy

TEMPERATURE AND HUMIDITY

The indoor temperature is always displayed in
the right bottom corner of the screen. To receive
outdoor temperature you can connect up to 3
outdoor sensors to the main unit.
Press the [ CH ] button to toggle between Channel
1-3.
SETTING TEMPERATURE ALERT
1. Press the [ ALERT ] button for approx. 2 seconds
and the current channel symbol starts flashing.
2. Press the [ ▲/CF ] or [ ▼/RCC ] button to set
the temperature.
3. Press [ ALERT ] button to confirm and continue
to the next setting.
4. Settings order: Outdoor high temperature
Outdoor low temperature
temperature Indoor low temperature
5. Press the Alert button to check the high/low
temperature.
6. When check the temperature alarm, press the
[ ▲/CF ] or [ ▼/RCC ] button to activate or
deactivate the Alarm for the currently selected
temperature Alert.
7. Press the [ CH ] button to select the channel.
When alert is triggered, press any button to stop
the alert. If you ignore the alarm, it will ring for 5
seconds of each minute.

MOON PHASES

This weather station is able to display the moon
phases for the northern hemisphere. Here the
moon grows from the right. This is because the
sunlit side of the moon in the northern hemisphere
moves from right to left.
BACKLIGHT
Press [ SNZ / LIGHT ] to activate backlight.
W h e n c o n n e c t w i t h a d a p t o r , p r e s s t h e
[ SNZ / LIGHT ] button to adjust the brightness.
The setting order: High light
When connect with batteries, press the
[ SNZ / LIGHT ] button to adjust the brightness.
The setting order: High light
Indoor high
Low light off.
Low light.