Maintenance And Storage; Environmental Protection - Bosch AXT 1600 HP Instrucciones De Servicio

F016 L70 438 - book.book Seite 4 Dienstag, 28. Februar 2006 3:26 15
Malfunctions
The motor does not run:
The overload protection has responded.
Switch off and wait for a few seconds.
Turn the rotational direction switch 3 to the left
position (backwards) and switch the machine
back on after a short period. After the blocking
has been removed, turn the rotational direction
switch 3 back to the right position.
Check the power supply cord, the plug and the
house fuse.
The material to be chopped is not pulled in:
The spiral cutting knives are running backwards:
Switch off and change direction of rotation.
The material to be shredded is jammed in the
feed intake 1: Turn the rotational direction
switch 3 to the left position (backwards) and
switch the machine back on. Remove the mate-
rial from the feed intake. After the blocking has
been removed turn the rotational direction
switch 3 back to the right position.
Re-feed thick branches such that the knives do
not immediately grasp the pre-cut notches again.
The spiral cutting knives are blocked:
Turn the rotational direction switch 3 to the left
position and switch the machine on. The spiral
cutting knives will now run backwards to release
the blocked up material (or the foreign body). Af-
ter the blocking has been removed turn the rota-
tional direction switch 3 back to the right position.
Longer material standing out from the ma-
chine could lash out when being pulled in
by the knives! Please keep at safe dis-
tance!
Direction of rotation remains unchanged after
switch-over:
Change the direction of rotation to the desired po-
sition after the machine has come to a complete
standstill.
12 • F016 L70 438 • 06.02

Maintenance and storage

Stop and remove plug from the power supply.
For safe and proper working, always keep the
machine and the ventilation slots clean.
The shredder must not be cleaned with high-pres-
sure cleaners or running water.
The tightness of the fastening screws of the under-
carriage should be checked from time to time.
To protect the machine from corrosion when storing
for a longer period, treat the spiral cutting knives with
Bosch preservation
order no. 1 609 200 399). This spray is harmless to
the environment and decomposable.
If the machine should fail despite the rigorous man-
ufacturing and testing procedures, repair should be
carried out by an authorised customer service centre
for Bosch power tools.
For all correspondence and spare parts orders, al-
ways include the 10-digit part number (typ) from the
nameplate of the machine!

Environmental Protection

Environmental label "Blue Angel".
Awarded for extra quiet operation.
Disposal
Power tools, accessories and packaging should be
sorted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into
household waste!
According to the European Directive
2002/96/EC on waste electrical and
electronic equipment and its incorpo-
ration into national law, power tools
that are no longer suitable for use must be sepa-
rately collected and sent for recovery in an environ-
mental-friendly manner.
English - 4
spray (accessory,