Starting And Stopping; Cold Engine; Warm Engine - Jonsered CS 2125T Manual De Instrucciones

Starting and stopping

WARNING! Note the following before
!
starting:
The chain brake must be engaged when
the chain saw is started to reduce the
chance of contact with the moving chain
during starting.
Never start a chain saw unless the bar,
chain and all covers are fitted correctly.
Otherwise the clutch can come loose and
cause personal injuries.
Place the machine on firm ground. Make
sure you have a secure footing and that
the chain cannot touch anything.
If you need to start the chain saw in the
tree, see instructions under the heading
Starting the saw in the tree, under the
section Working techniques.
Keep people and animals well away from
the working area.

Cold engine

Starting: The chain brake must be engaged when the
chain saw is started. Activate the brake by moving the
front hand guard forwards.
Set the switch to "I" position.
Primer bulb: Press the air purge repeatedly until fuel
begins to fill the bulb. The bulb need not be completely
filled.
134 – English
STARTING AND STOPPING
Ignition; choke: Pull the choke knob to the second-stage
position. The choke will close and the throttle lever will
then be set in the starting position.

Warm engine

Use the same starting procedure as for a cold engine.
Starting
Grip the front handle with your left hand and push the
chain saw to the ground. Grip the starter handle with your
right hand and pull out the starter cord slowly until you feel
a resistance (as the starter pawls engage) and then pull
firmly and rapidly. Never twist the starter cord around
your hand.
CAUTION! Do not pull the starter cord all the way out and
do not let go of the starter handle when the cord is fully
extended. This can damage the machine.
Push in the choke control as soon as the engine fires
which can be heard through a "puff" sound. Keep on
pulling the cord powerfully until the engine starts. When
the engine starts, quickly apply full throttle; the throttle
start lock will automatically disengage.
IMPORTANT! As the chain brake is still engaged the
speed of the engine must be set to idling as soon as
possible, this is achieved by quickly disengaging the
throttle lock. This prevents unnecessary wear to the
clutch, clutch drum and brake band.