Attaching The Plasma Display - Pioneer PDK-TS04 Manual De Instrucciones

Attaching the Plasma Display

The weight of a 50 inch plasma display is about 40 kg
(88 lbs), that of a 43 inch model is about 30 kg (66 lbs),
they have no depth, and are unstable. Therefore, at
Caution
least two people must assemble and install them.
Note
Be sure to install it on a flat stable location.
Insert the screws in the holes vertically and do not tighten
them with more force than necessary.
Make sure that you install the support columns reliably
according to the type of plasma display you have pur-
chased and the speaker settings with reference to the
procedure in, Assembling the Stand.
Attachment Method
1
Attaching the plasma display to the stand.
Fit the stand's support columns into the slots in the center of
the bottom of the plasma display then slowly insert them
directly into the slots. Be extremely careful not to insert the
support columns of the stand into any part of the plasma
display other than the stand insertion slots. Note that doing
so might damage the plasma display panel or its ports or
result in the warping of the stand.
2
Securing the plasma display with attach-
ment screws 2.
Secure them using the enclosed hexagonal wrench.
Illustration: when using support columns S
Line up the column
supports with the bottom
of the plasma display as
indicated in the accompa-
nying diagram.
Attachment screw 2
Illustration: when using support columns L
3
Securing the plasma display with attach-
ment screws 3.
Secure them using the enclosed hexagonal wrench.
Only when attaching speakers at the bottom
of the plasma display
4
Inserting the spacers.
Insert the spacers in the holes on the rotating platform
of the stand.
5
Attaching the speakers.
Refer to the operating instructions for the speaker for
the installation method.
Attachment screw 2
Attachment
screw 3
Spacer
15
En