Brush Replacement; Warranty - SPARKY Professional TV 1835 Instrucciones De Uso

has to be done by the manufacturer or his agent in order
to avoid a safety hazard.

BRUSH REPLACEMENT

When the carbon brushes are worn out, both brushes
must be replaced simultaneously with genuine brushes
at SPARKY service centre for warranty and post-war-
ranty service.
CLEANING
For safe operation always keep the machine and its ven-
tilation slots clean.
Regularly check to see if any dust or foreign matter has
entered the ventilation slots and the grills around the
switches. Use a soft brush and/or air jet to remove any
accumulated dust. Wear safety glasses to protect your
eyes whilst cleaning.
Exterior plastic parts may be cleaned with a damp cloth
and mild detergent if necessary.
WARNING: Never use alcohol, petrol or other
cleaning agent. Never use caustic agents to clean
plastic parts.
WARNING: Water must never come into con-
tact with the tool.
IMPORTANT! To assure product safety and reliability,
repairs, maintenance and adjustment (including brush
inspection and replacement) should be performed by
SPARKY certified service centres, always using genu-
ine replacement parts.
Problem
Motor does not run.
Chain saw does not operate at full
capacity.
Poor cutting performance.
Chain / guide bar overheats.
Original instructions
TROUBLESHOOTING
Probable cause
No supply power.
Faulty cable or plug .
Worn carbon brushes.
Other electrical fault.
. Extension cord is too long or its cross
section is too small.
Power supply voltage (e.g. generator) is
too low.
Improperly tensioned chain.
Worn-out (dull) chain.
There is no oil in tank.
Oil cap vents are clogged.
Oil passage clogged.
Chain is over-tensioned.
Worn-out (dull) chain.

Warranty

The guarantee period for SPARKY power tools is deter-
mined in the guarantee card.
Faults due to normal wear, overloading or improper han-
dling will be excluded from the guarantee.
Faults due to defective materials implemented as well as
defects in workmanship will be corrected free of charge
through replacement or repair.
The complaints for defective SPARKY power tools will
be recognized if the machine is sent back to the dealer
or is presented to the authorised warranty service centre
undismantled, in its initial condition.
Notes
Carefully read the entire Original Instructions before us-
ing this product.
The manufacturer reserves the right to make changes
and improvements to the products and to alter specifica-
tions without prior notice.
Specifications may differ from country to country.
Corrective action
Check the power supply, connect the
machine to another power outlet.
Take the machine to an authorized service
centre.
Take the machine to an authorized service
centre.
Take the machine to an authorized service
centre.
Use an extension cord with proper length and
cross section.
Connect the chain saw to another power
outlet.
Tension the chain properly.
Sharpen the chain or replace it.
Refill oil.
Clean the cap vents.
Clean oil passage outlet.
Tension chain properly.
Sharpen the chain or replace it.
13
EN