4-1. Software upgrade – Controller
a.
Transfer "CONT_D_W.bin" file to a USB stick. Do not place inside a folder
b.
Ensure that the unit is turned off and plug the USB into USB port on the
back of controller
c.
Press and hold SET button and turn on the Power switch
d.
MODE LED is on while checking upgrade file
e.
Software upgrade takes about 10 seconds
(Each LED lights in sequence, all LEDs light on and then off )
f.
Once upgrade is completed, unit reboot(reset) the system
g.
If controller does not recognize USB, MODE /Tracking /Lock LEDs blink
6 times and restart
h.
If upgrade is failed, all satellite LEDs blink till the unit is turned off
4-2. Software upgrade - Main board
a.
Transfer "MAIN_D_W.bin" file to a USB stick. Do not place inside a folder
b.
Ensure that the unit is turned on and plug the USB into USB port of main
board (inside antenna)
c.
Press and hold UPDATE button and then press RESET button
(There may be noise when pressing RESET button. It is not faulty.)
d.
Red and green LEDs are on while checking upgrade file
e.
Software upgrade takes about 10 seconds
f.
Once upgrade is completed, red LED is off and only green LED remains on
g.
If main board does not recognize USB, red and green LED blink 5 times and
restart
h.
If upgrade is failed, red LED blinks 5 times and restart
8
4. Software upgrade
USB port
Update button
Red & Green LED
Reset button