Sleep Mode - SELFSAT SNIPE DRIVE DiSEqC 1.1 Manual De Usuario

B. Stationary mode (Option)
a. Ensure that the unit is turned off
b. Press and hold MODE button, and turn on the power switch
c. All satellites LEDs light on while booting the system (15~30 seconds)
d. The last status satellite is automatically selected to start searching
(Tracking LED is off as stationary mode does not require tracking)
e. When Lock LED becomes solid this means the satellite is found
f. If the other satellite is desired, move to the correct satellite and press SET to
confirm the new satellite
For example :
C. DiSEqC 1.1 setting
Set-Top-Box power detection for DiSEqC is always on but works when
stationary mode is selected.
Refer SNIPE DRIVE's pre-set satellites for DiSEqC when user setup at STB.
NO
1
2
3
D. Sleep mode
a. For automatic sleep mode, when the vehicle keeps stationary status for
more than 1 minute, it is changed to sleep mode
b. For manual sleep mode, when Mode button is pressed for about 5 seconds,
the LED which points the receiving satellite shows sleep mode by switching
on and off LED
6
Mode LED is ON if stationary mode is selected
LNB
LNB 1
LNB 2
LNB 3
Satellite
Astra 2
Astra 1
Hotbird