Determining The Centre Of Gravity And Positioning The Transport Trolley And Jack - Jung JH 10 G-plus EX Instrucciones De Servicio

4.2.1 Determining the centre of gravity and
positioning the transport trolley and jack
DANGER
Before a jack is used on the load to be lifted, the
centre of gravity of the load to be lifted must be
determined. Otherwise, tipping or slipping can lead to
injuries or even to fatal accidents. Always determine
the centre of gravity before using JUNG jacks.
The centre of gravity must always be determined before
using a JUNG jack on the load to be lifted. For this
purpose, the entire weight of the load to be lifted must
be determined before the start of the lifting operation.
The following formula can be used for the selection
of the appropriate jack with a sufficient load-bearing
capacity:
Minimum load of the jack = (the load to be
lifted in kg) x (safety factor of 1.25)
Example:
Weight of the load 4000 kg x 1.25 = 5000 kg.
The jack must have a load-bearing capacity of 5000 kg.
WARNING
For safety reasons, using multiple jacks with different
load-bearing capacities is not permissible.
If several jacks are used, all of which have the same
carrying capacity, they must be placed under the load
such that each jack is subjected to the same share of
the load to be lifted. For this purpose, the centre of
gravity must be determined in advance.
> To determine the centre of gravity using JUNG jacks,
the pressure gauge for jacks
(order no. 94 001 024-B, additional accessory) must
be used.
© JUNG Hebe- und Transporttechnik GmbH
> Connect the pressure gauge to the hydraulic
connection.
Above: Example 1 - Ideal case
Below: Example 2 - Complicated case
The two examples in the diagram illustrate that the
centre of gravity can vary depending on the weight and
shape of the load to be lifted.
Calculation of the centre of gravity on the
complicated case (example 2)
Jacks of the JH / JH EX / JHS series
1 mm
≤
- 49 -