Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Input, output and audio controls
1:
Cooler
1:
Cooler
2
3
4
5
6
7
1. COOLERS:
It provides cooling of the amplifier. Install in a cool place
without obstruction of air inlets and outlets.
2. INPUT:
Input of the signal to be amplified. Connect to the radio/player
through high quality shielded RCA cables to prevent unwanted noise.
3. LEVEL:
Signal level control in the amplifier input.
4. CROSSOVER
• FILTRO HIGH PASS (HPF):
This variable control allows you to select the
initial frequency from 10Hz to 90Hz that will be reproduced by the amplifier.
• FILTRO LOW PASS (LPF):
This variable control allows you to select the final
frequency from 90Hz to 12KHz that will be reproduced by amplifier.
• BOOST:
Variable control for bass boost from 0 to + 10dB.
• FREQ:
Variable control for BASS boost action from 30Hz to 70Hz.
6. FLAT:
This switch allows you to turn the FLAT mode on or off. Settings made on
the CROSSOVER and BOOST controls will be turned off when using this mode.
7. CONECTOR DE SAÍDA (SPEAKERS):
MONO output of amplified signal
for speakers connection. Check the minimum impedance and polarities
before performing the installation.
12
Tabla de contenido
