REMS Helix VE Instrucciones De Servicio página 18

eng
2.7. Operating the safety switch
If the safety switch (5) is only pressed slightly, the LED work light (6) lights, the quick-clamping chuck (1) does
not yet turn. When the pressure is increased the quick-clamping chuck turns at slow speed. The highest speed
is achieved when the safety switch (5) is pressed right in.
3. Operation
REMS Helix VE is equipped with a safety switch (5). This enables the drive unit to be stopped at any time
but especially in the event of danger.
3.1. Drilling
Only apply REMS Helix VE to the workpiece to be drilled when it is off. Press the safety switch (5) a little at
first, then press in fully.
3.2. Turning in/loosening screws
Only apply REMS Helix VE to the screw head when it is off. As soon as the bit is firmly in the screw head,
press the safety switch (5) at first only a little and then press in fully.
NOTICE
Switch off the drive unit immediately if the safety clutch responds during operation.
3.3. Removing burr with REMS REG
Set the preselection lever for the speed range (3) to "Lo" and the rotation direction switch (4) to right-hand
rotation. Press the safety switch (5) fully in. Press the pipe to be deburred carefully against the pipe deburrer.
CAUTION
Danger of injury! Do not reach into the area of the moving pipe deburrer!
3.4. Low discharge protection
REMS Helix VE is equipped with a low discharge protection. This switches off the drive unit as soon as the
battery needs recharging. In this case remove the battery and charge with the REMS rapid charger.
4. Service
4.1. Maintenance
WARNING
Pull out the mains plug or remove the battery before doing maintenance work!
Keep the power tool clean. Blow out the soiled quick-clamping chuck (1).
Clean plastic parts (e.g. housing, batteries) only with the REMS CleanM (Art. No. 140119) or a mild soap and
a damp cloth. Do not use domestic cleaning agents. Do not use household cleaners. These often contain
chemicals which can damage the plastic parts. Never use petrol, turpentine, solvent or similar products for
cleaning plastic parts.
Make sure that liquids never get onto or inside the power tool. Never immerse the power tool in liquids.
4.2. Inspection/repair
WARNING
Pull out the mains plug or remove the battery before carrying out maintenance or repair work! This
work may only be performed by qualified personnel.
The gear of the REMS Helix VE is maintenance-free. The carbon brushes of the DC motor wear. These cannot
be replaced; the DC motor must be replaced.
18