Pump Installation; Important - Polygroup SUMMER WAVES SKIMMERPLUS SFX600 Manual Del Usuario

Pump Installation

7. From inside the Skimmer Canister
pivot slots, one after another. The Weir should now stand upright but not stuck.
Push-in
9. You can now fill the pool with water up to between the MIN and MAX markings on the inside of Skimmer Seal Ring
The water level should be
between the min and max
markers located inside the
Skimmer Seal Ring.
Max. Level
Min. Level
1. Plug the GFCI Power Cord Set
2. To turn on the Pump, press the RESET button of the GFCI Plug.
3. From inside the pool, check if the water flow from the RF Diverter
returning to the pool. If not, or if you feel a reduction in flow, clean or replace the Filter Cartridge
FILTER CARTRIDGE USE & CARE (p. 11) as well as Symptom 2 of TROUBLESHOOTING GUIDE (p. 17).
4. To turn the Pump off, press the TEST button of the GFCI Plug, and unplug it from the power outlet.
5. VERY IMPORTANT: Check and adjust the pH and chlorine levels daily. FILTER PUMP ALONE
WILL NOT PREVENT ALGAE FROM GROWING IN POOL WATER; THIS CAN ONLY BE DONE
BY MAINTAINING PROPER CHLORINE AND pH LEVELS AT ALL TIMES. For details,
see POOL WATER CARE (p. 12).
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8AM to 5PM MST, Monday-Friday.
10
, snap the pins of the Weir
9 8
Weir installation
finished.
Inside Pool Wall
USE OF PUMP
26 to a properly grounded receptacle at least 15 feet (4.5m) away from the pool.
19
Extended operating days and hours during peak season requirements.
8. Slide close the Top Cover
into the
is correct. It should feel like a solid stream of water
7 . For details, see
IMPORTANT: Do NOT connect to a timer device!
onto the Skimmer Canister
5
9
Inside Pool Wall
22 .
How to use the GFCI plug
*Do not connect
to a timer device
.
9
5
Press
"RESET"
Button
To Start
Pump
Operation