Setup And Startup - Fiap Air Active OxyFlow Instrucciones De Uso

Air Active OxyFlow
10
GB

Setup and startup

The device is supplied as a complete set with power supply and all necessary ac-
cessories. The float is already delivered pre-assembled. If the float is not installed,
follow these assembly instructions:
The device includes LED lighting. To remove the lighting, turn the light with one of
the three edges on the transparent cover until it is lined up with the small gap
on the float and carefully push the light downwards out of the float (light pressu-
re must be sufficient, do not use force! It may be necessary to move the parts of
the float a little, which facilitates the installation and removal of the lights). If all
lights are not pre-assembled, first check whether all caps are screwed on. Ca-
refully insert the lights in sequence from bottom to top into the holes provided
in the float (also note the position of the edges in the lid). Then mount the pump
housing with the pump on the float. To do this, insert the housing with the feed
screw up into the float. Fasten the pump housing with the three long retaining
pins. Place the pre - assembled diffuser in its intended position in the basin and
fix it with the supplied cord. It is important that the ventilator is secured on at
least two opposing sides. Finally, connect the power supply to the supplied trans-
former. As soon as all preparations have been made and the aerator is immersed
in the tank, it can be put into operation. Watch the running aerator for about
30 minutes and check the barrel for unusual noise and steady water flow. If the
aerator does not run clean for more than 30 minutes, there is a fault and must
be repaired.
IMPORTANT: The aerator has two operating modes. In mode 1, the aerator runs
continuously at maximum power. In mode 2, the aerator runs in intervals and va-