MTD 510 Serie Manual Del Operador página 9

Tail Light Installation (If equipped)
The mounting brackets for the tail light are installed. Refer to the
installation sheet included with the tail light kit to mount the
lights and route the harness.
Set-Up
Gas and Oil Fill-Up
Service the engine with gasoline and oil as instructed in
the engine manual packed with your log splitter. Read the
instructions carefully.
WARNING!
Use extreme care when handling
gasoline. Gasoline is extremely flammable and the
vapors are explosive. Never fuel the machine
indoors or while the engine is hot or running.
NOTE: Your log splitter may be shipped with motor oil in the
engine. You MUST check the oil level before operating. Be careful
not to overfill. Gasoline can be added to the engine when the log
splitter is in either the horizontal or vertical position. However,
there are less obstructions when the splitter is in the vertical
position.
Preparing the Log Splitter
1. Lubricate the beam area (where the splitting wedge will
slide) with engine oil. Do not use grease.
2. Remove the vented reservoir dipstick, which is located in
front of the engine on top of the reservoir tank. See Fig. 3-7.
NOTE: The log splitter is filled to the proper operating level
from the manufacturer with Shell Tellus® 32 Hydraulic Fluid.
However, you MUST check the fluid level before operating.
If not filled, proceed with the following steps:
WARNING!
Much of the original fluid has been
drawn into the cylinder and hoses. Make certain to
refill the reservoir to prevent damage to the
hydraulic pump.
3. Check the fluid level using the dipstick. See Fig. 3-7. Do not
overfill.
Dipstick
Figure 3-7
4. Replace the vented dipstick securely, tightening it until the
top of the threads are flush with the top of the pipe.
5. Disconnect the spark plug and prime the pump by pulling
the recoil starter as far as it will go. Repeat approximately
10 times.
6. Reconnect the spark plug wire and start the engine
following the instructions in the Operation Section.
7.
Use the control handle to engage the wedge to the farthest
extended position. Then retract the wedge.
8. If neccessary, refill the tank as specified on the dipstick.
NOTE: Approved fluids include Dexron® III / Mercon®
automatic transmission fluid, Pro-Mix™ AW-32 Hydraulic Oil
or a 10 Weight AW hydraulic oil. It is not recommended that
fluids be mixed, so to top off the reservoir tank use Shell
Tellus® 32 Hydraulic Fluid.
NOTE: Failure to refill the tank will void the splitter's
warranty.
9. Extend and retract the wedge 12 complete cycles to
remove any trapped air in the system (the system is "self-
bleeding").
10. Refill the reservoir within the range marked on the dipstick.
NOTE: Some fluid may overflow from the vent plug as
the system builds heat and the fluid expands and seeks a
balanced level.
Tire Pressure
The max recommended operating pressure is 30 psi. Do
not, under any circumstances, exceed the manufacturer's
recommended psi. Maintain equal pressure on all tires.
Reservoir
Tank
WARNING!
Excessive pressure when seating beads
may cause the tire/rim assembly to burst with force
sufficient to cause serious injury.
s 2 — a
ectiOn
& s -u 9
sseMbly et p