RECARO Apex Instrucciones De Uso página 12

Final installation
„ Tighten all 4 mounting screws (10) with a tight­
ening torque of 22 Nm +2/–3 Nm.
DANgER
Risk of serious injury if the racing shell be-
comes detached from its anchoring.
„ Use only the supplied micro­encapsulated
screws when installing the racing shell.
„ Use the supplied micro­encapsulated screws
only once.
„ Tighten all screws with the specified torque.
3.4. Fitting the protector on the HANS system
(Figure D)
NOtICE
the racing shell cover can be damaged by the
HANS system without a protector!
„ No warranty claims will be possible without the
HANS protector fitted.
„ fit the factory­supplied protector (7) onto the
HANS system (8) using the self­adhesive Velcro
fasteners (9).
To do this, guide the restraining straps of the
HANS system through the openings provided for
that purpose on the supplied protector.
3.5. Adapt the backrest cushion
(Figures E and F)
Refer to Page 3 for the associated
drawings.
There is a tapered cushion on the backrest for
supporting the lumbar vertebrae. This enables the
racing shell to be adjusted to suit the driver's indi­
vidual needs.
The default position is 200 mm below the top edge
of the rest cushion.
„ Pull the backrest cushion (3) firmly out of the
backrest's Velcro fastener and move the tapered
cushion.
3.6. Replacing/cleaning seat cushions
(Figure E)
Refer to Page 3 for the associated
drawings.
The seat cushion (2) can be removed for cleaning
or reupholstering.
„ Pull the seat cushion firmly off the Velcro fas­
tener.
The seat cushion can now be easily cleaned or
replaced. See page 13 for cleaning instructions.
12