Connecting The Interface And Power Supply Cables - Brother P-touch 9200DX Manual De Instrucciones

Connecting the interface and power supply cables

Connect the PT-9200DX to the computer according to the instructions below.
When connecting to the serial port:
1 Make sure that both the PT-9200DX and the computer are turned off.
2 Connect one end of the enclosed serial interface cable to the serial connector (IOIOI) of the PT-9200DX and the
other end of the cable to the serial port of the computer. For a Macintosh connection, connect the PT-9200DX to
either the modem or the printer port (preferably the modem port).
The serial (RS-232C) ports of some computers are shaped so that the serial interface cable cannot be con-
nected. If this is the case, use a commercially available adapter.
3 Insert the plug on one end of the power supply cord into the power supply jack on the PT-9200DX.
4 Insert the plug on the other end of the power supply cord into an AC outlet equipped with a grounding terminal.
Some locations may require the use of an adapter provided with a grounding wire. Connect this wire to the ground
terminal.
5 Turn on the PT-9200DX, and then turn on the computer.
4
Serial