Installing P-Touch Editor; P-Touch Editor & Printer Driver Installation; Installing P-Touch Editor Version 3.1; 95/98/Me/Nt 4.0/2000 Professional/Xp) - Brother P-touch 9200DX Manual De Instrucciones

Ocultar thumbs Ver también para P-touch 9200DX:

Idiomas disponibles

Before labels can be printed on the PT-9200DX, the P-touch Editor software and the PT-9200DX printer driver must be

installed.

P-touch Editor & Printer Driver Installation (for Windows

Install P-touch Editor Version 3.1 and the printer driver on a PC as described below.

Check that your system configuration meets the following requirements.

Computer: IBM PC or compatible

Operating system:

Serial interface: PC equipped with an x86 processor and a serial (RS-232C) port, and running Microsoft

Windows

USB interface:

PC equipped with a USB port, and pre-installed with Microsoft

Professional/XP

Some PCs pre-installed with Microsoft

Hard disk free space: At least 20 MB

A few hundred megabytes of additional free space may be needed when printing long labels or large amounts of

data.

Monitor: VGA or higher graphics card

Port: Serial or USB

Available memory: Minimum 32 MB

CD-ROM drive

Installing P-touch Editor Version 3.1

For a serial connection: Before installing the P-touch Editor software and the printer driver, connect the PT-

9200DX to the computer as described on page 4, and then turn them on.

For a USB connection: Do not connect the PT-9200DX to the computer before installing the P-touch Editor

software, otherwise it may not be installed correctly. Be sure not to connect the PT-9200DX until you are

instructed to do so.

1 Insert the P-touch Editor Version 3.1 CD-ROM into

the computer's CD-ROM drive. A dialogue box

automatically appears, allowing you to select the

language.

If the dialog box does not automatically appear, click

"My Computer" on the desktop, and then double-

click the CD-ROM drive containing the CD-ROM.

(For Windows

XP, click "My Computer" in the Start

menu, and then double-click the CD-ROM drive

containing the CD-ROM.)

Next, double-click "Setup.exe" to display the dialog

box.

2 Select the language for the Windows

system that you are using, and then click the OK

button. A dialogue box appears, allowing you to

select what to install.