Start Point Measuring; Station Point Setup - Pentax R-100 Serie Manual De Instrucciones

The following assumptions are made:
The current station is the fore sight point of the previous station which you select as a next
station.
The back sight point of current station is the previous station.
The following limitations are made.
More than one traverse route can't be measured at the same time.
Don't store the other data while you are measuring the traverse route.
When one traverse route is finished, perform the traverse calculation before you store the other data.
Don't turn the power supply off until the measurement at one start point or at one corner point is
completed.
Don't escape from the MEASURE screen, too.
You can't use the same PN in one Job. And you can't overwrite the PN in the traverse.
The same traverse route can't be calculated again.
Polar coordinates data of back sight and station points can't be seen in the POLAR EDIT function.
But it is sent properly in SEND POLAR DATA function.
Traverse
From the PowerTopoLite screen, press [F2][CALC] to view the CALCULATION screen.
Select 2.TRAVERSE and press the [ENT] key to view the TRAVERSE screen.

8.4.1 Start point measuring

Select 1.START POINT first to start new traverse.
Note
More than one traverse route can't be
measured at the same time.
Please start the new traverse route after
another traverse route is finished.
And press the [ENT] key to view the STATION POINT SETUP screen.
The / mark is used to scroll up / down. 6. PC is viewed by
CALCULATION
1. COGO
2. TRAVERSE
3. RDM
4. VPM
TRAVERSE
1. START POINT MEAS.
2. CORNER POINT MEAS.
3. FIXED CALC.
4. CLOSED CALC.
5. OPEN CALC.

STATION POINT SETUP

1. PN :
2. IH : 0000.000 m
3. TEMP : 27 C
°
4. PRESS : 994 hpa
5. ppm : 16 ppm
STATION POINT SETUP
2. IH : 0000.000 m
3. TEMP : 27 C
°
4. PRESS : 994 hpa
5. ppm : 16 ppm
6. PC :
80
ACCEPT
.
ACCEPT