Getting Started - Lorex LW2232 Manual De Instrucciones

1. Getting Started

The system comes with the following components:
2 X WIRELESS CAMERAS
2 X MOUNTING KITS
(Mounting kit contents may differ
from image)
2 X DOUBLE-SIDED TAPE
CHECK YOUR PACKAGE TO CONFIRM THAT YOU HAVE RECEIVED THE COMPLETE SYSTEM,
INCLUDING ALL COMPONENTS SHOWN ABOVE.
1 X WIRELESS RECEIVER
2 X WHITE CAMERA ANTENNAS
(PRE-ATTACHED)
W I RE LES S D I G I TA L SEC UR I T Y C A MER A S
LW2232
QUICK START GUIDE
A. Installing the Cameras g
Getting Started
L Loosen the two h Connect the camera power C t th
1 Mount the camera to the wall or 2 3
ceiling using the included screws. thumbscrews (1,2) 1 adapter to the camera.
Cable Notch and the adjustment Connect power
ring (3). Adjust the adapter to a 120V
2 AC power outlet.
NOTE: angle of the camera
until the desired view
If you run the cables 3
along the wall / ceiling, is set. Tighten the
you must run the cable thumbscrews and the
through the cable notch
on the base. This will adjustment ring to
Power cables are only weatherproof when fully
keep the camera base secure the camera
For outdoor use, installation in a flush to the wall / position. inserted at the connection point. Power cables not
sheltered location is recommended. ceiling when mounted. to be submerged in water.
B B. Installing the Receiver Installing the Recei e
This system comes with the
following components: Installing Multiple Wireless Cameras
OPTIONAL 3 Connect the receiver power
1
Use the included double-sided tape to securely adapter to the receiver.
2x wireless cameras
attach the receiver to a flat surface. Connect the power adapter
1x wireless receiver to a 120V power outlet.
2x antennas for cameras (pre-attached)
2x antennas for receiver (pre-attached) 2 Plug both BNC cables from the wireless receiver
3x power adapters (for cameras and receiver) into your DVR.
2x mounting kits for cameras
2x double-sided tape for receiver When installing multiple digital wireless security
cameras in the same environment maintain at least
4" / 10cm between the receivers to optimize camera
ATTENTION: performance.
Make sure to first connect and power
Installation Tips
on the cameras before powering on the
receiver. This will ensure a proper NOTE: It is not recommended to install more than 4 digital wireless
security cameras (2 receivers) in the same environment to
Before you permanently install your cameras: connection.
maintain optimal video frame rate performance.
Plan where and how they will be
positioned.
Determine where you will route the
It's all on the Web
cable that connects the camera to the Need to extend the wireless range?
power adapter.
See instruction manual for further details.
Scan the QR code or go to the
Verify the camera's performance by
observing the image on a monitor when address below for the complete
the camera is positioned where it will be user's guide.
permanently installed. REGISTER NOW TO RECEIVE
Avoid installing cameras in locations that
require the wireless signal to pass through 3-MONTHS EXTENDED WARRANTY lorex.ca/LW2230
cement, concrete and metal structures. This will
reduce the transmission range. www.lorextechnology.com/warranty
LW2232_Quick Start Guide_R3 Page 1
www.lorextechnology.com
QUICK START GUIDE
Getting Started
3 X POWER ADAPTERS
(FOR CAMERAS & RECEIVER)
2 X BLACK RECEIVER ANTENNAS
(PRE-ATTACHED)
11
1