Important - IPC Mitho Manual De Instrucciones

USING
THE CLEANER
CONTROL PANEL.
A - On/off switch.
B - Temperature regulator.
STARTING THE CLEANER.
1) Turn on the water supply tap (fig. 4A).
2) Connect the water cleaner to the mains electricity supply via
the omnipolar switch or by plugging the plug into the socket.
3) Start the cleaner by turning the selector switch to pos. 1
(fig. 6A).
The high pressure water jet generates a reaction force in the
lance. Keep a firm grip on the lance handle.
4) Press the trigger on the gun and begin washing.
5) To use the cleaner with hot water, turn the temperature regu-
lator (fig. 6B) to the recommended washing values.
For some models turn the ignition switch (fig. 6A) onto the
hot water position before effecting the operations described
in this point.
In water cleaners with the "Total Stop" system, the motor
!
starts and stops when the lever on the lance handle is actioned
or released.
Do not block the handle lever in the delivery position.
!

IMPORTANT!

To eliminate any impurities
or air bubbles from the wa-
ter circuit we advise starting
the cleaner for the first time
without the lance and letting
the water run out for a few
seconds.
Impurities could block the
nozzle and cause malfunc-
tion (Fig. 7).
English
STOPPING THE CLEANER
1) Switch off the burner by
turning the pressure regulator
to pos. "0" (fig. 6B).
2) Let the cleaner run with
cold water only for at least
30 seconds to cool down the
boiler.
3) Stop the cleaner by
turning the selector switch to
pos. "0" (fig. 6A).
FIG. 6
4) Discharge the pres-
sure from the H.P. hose by
pressing the trigger on the gun
(fig. 5A).
5) Disconnect the water
cleaner from the mains electri-
city supply via the omnipolar
switch or by unplugging the
plug from the socket.
6) Turn off the water sup-
ply tap (fig. 4A).
If the water cleaner is left,
even temporarily, turn it off by
!
using the omnipolar switch or
by unplugging the plug from
the socket.
Water cleaners with the
"Total Stop" device should
!
be considered as off when
the omnipolar switch is in
the "O" position or the plug is
unplugged from the socket.
When the water cleaner
!
is not used, close the safety
device on the handle.(fig. 9)
Dry use of the water
!
cleaner causes serious dam-
age to pump gaskets.
FIG. 7
- 20 -
USING THE MULTIREG
ADJUSTABLE NOZZLE.
(fig. 8)
Pressure must be selected
with the gun switched off.
Low pressure washing and
detergent suction.
Shift the nozzle towards the
gun.
Washing at high pressure
with a concentrated jet of
water
Turn the nozzle in a clockwise
direction.
Washing at high pressure
with a fan-shaped jet of
water
Turn the nozzle in an anti-
clockwise direction.
FIG. 8
FIG. 9