Dometic CoolPower MPS 50 Instrucciones De Montaje página 7

MPS50
• Never pull the plug out of the socket by the connection cable.
• Store the device in a dry and cool place.
2.2 Safety when installing the device
D
DANGER!
• Never mount the device anywhere where there is a risk of gas or dust
explosion.
!
CAUTION!
• Ensure that the device is standing firmly.
The device must be set up and fastened in such a way that it cannot tip
over or fall down.
A
NOTICE!
• Do not expose the device to a heat source (such as direct sunlight or
heating). Avoid additional heating of the device in this way.
• Set up the device in a dry location where it is protected against splash-
ing water.
2.3 Safety when connecting the device electronically
D
DANGER! Danger of electrocution
• For installation on boats:
If electrical devices are incorrectly installed on boats, corrosion dam-
age might occur. Have the device installed by a specialist (marine)
electrician.
• If you are working on electrical systems, ensure that there is somebody
close at hand who can help you in emergencies.
!
WARNING!
• Always use sockets which are grounded and secured by residual cur-
rent circuit breakers.
• Make sure that the lead has a sufficient cross-section.
• Lay the cables so that they cannot be damaged by the doors or the
bonnet.
Crushed cables can lead to serious injury.
EN
General safety instructions
7