Beper 40.490 Manual De Instrucciones página 8

Wall-mounted Hair dryer Use instructions
Before cleaning, always unplug the appliance.
To protect against electric shock, do not immerse cord, plug or any
parts of the appliance into water or other fluids.
Do not hold the appliance with wet hands or feet.
Do not hold the appliance with naked feet.
Do not expose the appliance to atmospheric agents such as rain,
wind, snow, hail.
Do not use the appliance near explosives, highly flammable mate-
rials, gases, burning flames, heaters.
Do not allow children, disabled people or every people without expe-
rience or technical ability to use the appliance if they are not properly
watched over. Close supervision is necessary when any appliance
used by or near children.
Make sure that children do not play with this appliance.
If you decide not to use the appliance any longer, make it unservice-
able by simply cutting the supply cable after disconnecting the plug
from the socket.
ALSO MAKE ANY DANGEROUS PARTS UNSERVICE-
ABLE, ESPECIALLY FOR CHILDREN WHO COULD
PLAY WITH THE APPLIANCE.
Product description Fig.A
1. Hair dryer
2. Wall base
3. Plug
INSTRUCTIONS FOR MOUNTING
TO REDUCE RISK OF DEATH FROM ELECTRIC SHOCK, DO NOT INSTALL THE APPLIANCE NEXT TO
BATH TUBS OR SINKS.
IT IS IMPORTANT TO INSTALL THE APPLIANCE AT A PROPER HEIGHT, AS IT IS NATURAL FOR COILED
ELECTRICAL WIRE TO LOOSEN AND STRETCH WITH TIME.
NOTE: IT IS STRONGLY RECOMMENDED TO CONTACT QUALIFIED PERSONNEL FOR INSTALLATION,
TO AVOID DAMAGES CAUSED BY ERRONEOUS MOUNTING OF THE APPLIANCE.
1. Lay the wall base flat against the wall, and use the holes as a guide to find and mark the desired position for
the installation
2. Remove the wall base and start drilling where the marks on the wall have been traced; use a drilling tip of 6
mm or ¼"
3. Insert the plastic anchors into the holes
4. Remove the hair dryer from the wall base, and lay the wall base flat on the wall, with holes in correspondence
with the anchors, and insert the screws
5. Fasten clockwise until the wall base is firmly fixed and steady
6. Insert the hair dryer into the wall base e plug into the wall socket
OPERATING INSTRUCTION
To reduce drying time, before using the appliance it is recommended to gently dry the hair with a towel to remove
excess water, to brush it to remove any tangle and divide it into sections, that will be dry separately.
1. Ensure that the ON/OFF switch is set on 0 before plugging the appliance
8