Tabla de contenido
Idiomas disponibles
Idiomas disponibles
* The insertion guides facilitate the installation of the safety
seat with the aid of the ISoFIX securing points and prevents
damage to the upholstery. when not in use they should
be removed and stored in a safe place. In vehicles with
a reclining back the insertion guides should be removed
before the seat is reclined. Problems that may arise are
generally the result of accumulation of dirt or foreign bodies
in the insertion guides and the clasps. To solve this type of
problem simply clean the part in question.
5. make sure the 5-point harness of the safety seat has been
correctly installed (see section 3).
6. Follow the steps described in section 3.7.
7. Recline the seat fully. Pull the lever
(12)
forward and adjust
the angle of recline to position 4 without releasing the lever.
Release the lever when the seat is in the desired position (fig.
10).
8. Make sure the Isoclick Fix arms are displayed to install the car
seat backward facing (group 0+/1).
9. Place the seat in the back seat of the vehicle in opposite
direction of travel.
10. Hold the safety seat with both hands and insert the two
Isoclick Fix arms
(19)
firmly into the insertion guides
they fasten with a click on both sides. The red button will
partially change to green on both sides (fig. 11).
11. Shake the seat to check that it is correctly anchored to the
vehicle's ISOFIX points.
• Uninstalling the Isoclick Fix system
1. To free the Isoclick Fix anchoring, press the Isoclick Fix system
unlock buttons (21), in order to free the seat from the vehicle
ISOFIX anchoring system (fig. 12).
42
fig. 10
1 2 3
4
CLICK
fig. 11
(26)
until
fig. 12
4.2 Fastening the seat with the vehicle's belt in a rearward-
facing installation. Group 0+/1. (Optional)
1. make sure the 5-point harness of the safety seat has been correctly
installed (see section 3).
2. Follow the steps described in section 3.7.
3. Recline the seat fully. Pull the lever
of recline to position 4 without releasing the lever. Release the lever
when the seat is in the desired position (fig. 10).
4. Place the seat in the back seat of the vehicle in opposite direction
of travel (fig. 9).
OK
5. Take out the reducer cushion (4). Pass the abdominal strap of the
seat belt through the lower seat guides
seat. Buckle the vehicle seat belt until you hear a click (fig. 13).
6. Pass the abdominal strap of the seat through the upper guide
as shown (fig. 14/A).
7. Take up the remaining slack of the diagonal section of the 3-point seat
belt (fig. 14). and make sure it is as tight fitting as possible. Ensure the
straps are not twisted or knotted at any point.
8. Place the reducer cushion in his original place.
9. Follow the steps in section 5, securing the child with the 5-point
harness.
5. PLACING THE CHILD IN THE SEAT. GROUP 0+/1
TIP: The more snugly the harness fits over the child's body, the better
the child will be protected. therefore avoid putting thick clothes on your
child under the belt.
BNO FIX 0+123
www.babyqs.com
fig. 13
(15)
forward and adjust the angle
(11)
and underneath the
fig. 14/A
(16)
16
(16)
CLICK
fig. 14
Diagonal belt guide
(group 0+/1).
43
Tabla de contenido
