EN-11
6.3 Compliance
Compliance to the following standards is indicated by the corresponding mark on the product.
Mark
Standard
This product conforms to the EMC directive 2004/108/EC and the Low Voltage Directive
2006/95/EC. The complete declaration of Conformity is available from Ohaus Corporation
AS/NZS4251.1 Emission; AS/NZS4252.1 Immunity
CAN/CSA-C22.2 No. 1010.1-92; UL Std. No. 3101-1
Important notice for verified weighing instruments
The first stage of the initial verification has been carried out at the manufacturers work. It comprises all
tests according to the adopted European standard EN 45501:1992, paragraph 8.2.2.
If national regulations limit the validity period of the verification, the user of the weighing instrument must
strictly observe the re-verification period and inform the respective W+M authorities.
ISO 9001 Registration
In 1994, Ohaus Corporation, USA, was awarded a certificate of registration to ISO 9001 by Bureau Veritus Quality
International (BVQI), confirming that the Ohaus quality management system is compliant with the ISO 9001
standard‟s requirements. On May 15, 2003, Ohaus Corporation, USA, was re-registered to the ISO 9001:2000
standard.
Disposal
In conformance with the European Directive 2002/96 EC on Waste Electrical and
Electronic Equipment (WEEE) this device may not be disposed of in domestic waste. This
also applies to countries outside the EU, per their specific requirements.
Please dispose of this product in accordance with local regulations at the collecting point
specified for electrical and electronic equipment.
If you have any questions, please contact the responsible authority or the distributor from
which you purchased this device.
Should this device be passed on to other parties (for private or professional use), the
content of this regulation must also be related.
Thank you for your contribution to environmental protection.
Weighing Instruments verified at the place of manufacture bear one of the
preceding mark on the packing label and the green „M‟ (metrology) sticker
on the descriptive plate. They may be put into service immediately.
Weighing Instruments to be verified in two stages have no green „M‟
(metrology) on the descriptive plate and bear one of the preceding
identification mark on the packing label. The second stage of the initial
verification must be carried out by the approved service organization of
the authorized representative within the EC or by the national weight &
measures (W+M) authorities
Carat / Gold