Dremel 876 Instrucciones De Funcionamiento Y Seguridad página 2

Idiomas disponibles

Idiomas disponibles

SM 1619X04037 01-09:SM 1619X04037 01-09 8/25/10 7:32 AM Page 2
Read and understand all instructions. Failure to follow all instructions
W RNING
listed below, may result in electric shock, fire and/or serious personal injury.
ImPORTANT SAFETy AND OPERATINg INSTRUCTIONS
Before using battery charger, read all
instructions and cautionary markings on
(1) battery charger, (2) battery pack, and (3)
product using battery.
Use only the charger which accompanied
your product or direct replacement as
listed in the catalog or this manual. Do not
substitute any other charger. Use only Dremel
approved chargers with your product. See
Functional Description and Specifications.
Do not disassemble charger or operate the
charger if it has received a sharp blow,
been dropped or otherwise damaged in any
way. Replace damaged cord or plugs
immediately. Incorrect reassembly or damage
may result in electric shock or fire.
Do not recharge battery in damp or wet
environment. Do not expose charger to rain
or snow. If battery case is cracked or
otherwise damaged, do not insert into
charger. Battery short or fire may result.
Charge only Dremel approved rechargeable
batteries. See Functional Description and
Specifications. Other types of batteries may
burst causing personal injury and damage.
Charge battery pack in temperatures above
+32 degrees F (0 degrees C) and below
Battery Care
When batteries are not in
W RNING
tool or charger, keep them
away from metal objects. For example, to
protect terminals from shorting DO NOT place
Battery Disposal
Do not attempt to disassemble
W RNING
the battery or remove any
component projecting from the battery
terminals. Fire or injury may result. Prior to
disposal, protect exposed terminals with heavy
insulating tape to prevent shorting.
Lithium-ion Batteries
If equipped with a lithium-ion battery, the battery
must be collected, recycled or disposed of in
an environmentally sound manner.
"The EPA certified RBRC Battery
Recycling Seal on the lithium-ion
(Li-ion) battery indicates Robert
Bosch
voluntarily participating in an industry program
"SAVE THESE INSTRUCTIONS"
Battery/Charger
Tool
Corporation
+113 degrees F (45 degrees C). Store tool
and battery pack in locations where
temperatures will not exceed 120 degrees F
(49 degrees C). This is important to prevent
serious damage to the battery cells.
Battery leakage may occur under extreme
usage or temperature conditions. Avoid
contact with skin and eyes. The battery
liquid is caustic and could cause chemical
burns to tissues. If liquid comes in contact with
skin, wash quickly with soap and water. If the
liquid contacts your eyes, flush them with
water for a minimum of 10 minutes and seek
medical attention.
Place charger on flat non-flammable
surfaces and away from flammable
materials when re-charging battery pack.
The charger and battery pack heat during
charging. Carpeting and other heat insulating
surfaces block proper air circulation which may
cause overheating of the charger and battery
pack. If smoke or melting of the case are
observed unplug the charger immediately and
do not use the battery pack or charger.
Use of an attachment not recommended or
sold by Dremel will result in a risk of fire,
electric shock or injury to persons.
batteries in a tool box or pocket with nails,
screws, keys, etc. Fire or injury may result.
DO NOT PUT BATTERIES INTO FIRE OR
ExPOSE TO HIgH HEAT. They may explode.
to collect and recycle these batteries at the
end of their useful life, when taken out of
service in the United States or Canada. The
RBRC program provides a convenient
alterative to placing used Li-ion batteries into
the trash or the municipal waste stream, which
may be illegal in your area.
Please call 1-800-8-BATTERY for information
on Li-ion battery recycling and disposal
bans/restrictions in your area, or return your
batteries to a Skil/Bosch/Dremel Service
Center for recycling. Robert Bosch Tool
Corporation's involvement in this program is
part of our commitment to preserving our
environment and conserving our natural
is
resources."
2-
-
loading