Storage; Troubleshooting - Mafell ERIKA 60 E Manual De Instrucciones

In order to avoid a too large temperature rise of the
motor check occasionally that there is no dust deposit
on its surface.
7

Troubleshooting

Some of the most frequent defects and their causes are listed in the following chart. In case of other defects,
contact your dealer or the MAFELL customer service.
Defect
Machine cannot be switched on
Machine switches off
automatically during idling
Machine stops while cutting is in
process
Workpiece jams when feeding
Burn marks on the cut surfaces
Danger
Determining the causes for existing defects and eliminating these always
requires increased attention and caution. Pull the mains plug beforehand!
Cause
No mains voltage
Mains fuse defective
Carbon brushes worn
Mains failure
Mains failure
Machine overloaded
Blunt saw blade
Stop rail of the universal and/or
the multi-function stop is not
parallel to the saw blade
The saw blade used is unsuitable
for the task or blunt
-29-

6.3 Storage

If the machine is not used for a longer period of time,
it has to be carefully cleaned. Spray bright metal parts
with a rust inhibitor.
Elimination
Check power supply
Replace fuse
Take the machine to a MAFELL
customer service shop
Check mains back-up fuses
The machine does not restart due
to the installed under-voltage
protection and must be turned on
again after power has returned
Check mains back-up fuses
Reduce feed speed
Hold workpiece and turn motor off
immediately. Then exchange the
saw blade
Readjust the stop rail, see chapter
5.6
Replace saw blade