Attaching The Roller Cap - RADEMACHER RolloTube RTBS 6/28 Instrucciones De Uso

Preparatory work when using precision tubes (Figures
5.d
5.e
5.f
Inserting the roller capsule (Figure
1. Slide the roller capsule (4) into the winding shaft (5), then place
the ball bearing (2) on the axle pin (3).
48
Push the tubular motor into the precision tube.
3.
4. Mark four fixing holes and drill these through the precision tube into
the driver.
CAUTION
Never drill deeper than 10 mm into the driver.
Never drill close to the drive as this will cause it to malfunction.
5. Screw fix or rivet the precision tube to the driver using self-tapping
screws or four blind rivets.
)
5
- )
5.a 5.f
GB