Pushing The Tubular Motor Into The Winding Shaft; Preparatory Work When Using Precision Tubes - RADEMACHER RolloTube RTBS 6/28 Instrucciones De Uso

Slide the tubular motor into the winding shaft (Figure
STOP
1. First slide the driver (8) into the winding shaft (5).
IMPORTANT
For winding shaft with interior seams, the motor (9) must have
sufficient clearance.
For RTBS ... / RTBM ... only
Preparatory work when using precision tubes (Figures
5.a
RolloTube RTBS...
5.b
RolloTube RTBM...
5.c
Never strike the motor (9) violently
to insert it in the winding shaft (5).
This will destroy it.
1 2
1 2
5
2. Next, press the winding shaft (5) completely onto the adapter (10).
IMPORTANT
Take care that the adapter (10) does not slide off of the limit ring (18)
on the drive head (12) during assembly, or a malfunction will occur;
see Page 54.
5.a
1. Measure the distance between the adapter and the rear third of the
driver and mark this distance on the precision tube.
2. Saw a notch 1 at the end of the precision tube so that the raised
2
part of the adapter can be pushed fully into the tube.
NOTE
There must be no play between the notch
2
part .
The dimensions of the notch
motor, see figures.
)
- )
5.f
1 and the raised
1 depend on the type of tubular
GB
47