britech BT 36 Manual De Instrucciones página 37

PETROL CHAIN SAW FOR TREE SERVICE USER MANUAL
Fig. 16 shows an example of a temporary
foot strap.
8.6 STARTING THE CHAIN SAW ON A TREE
To start the chain saw on a tree, the operator
must:
IF THE ENGINE IS COLD
- Ask the operator on the ground to start and
warm up the engine.
- apply the chain brake (fig. 30);
Fig. 30
FOR THE OPERATOR
STANDING ON THE TREE:
As the engine is pre-heated,
move lever (C) as shown in
the picture.
HOLD THE CHAIN SAW IN ONE OF THE 2
WAYS SPECIFIED BELOW:
FIRST OPTION – Tightly hold the front handle
with your left hand, keeping the chain saw away
from your body and pull the starting cord with
your right hand.
SECOND OPTION – Tightly hold one of the two
handles with your right hand, keeping the chain
saw away from your body and pull the starting
cord with your left hand.
ways apply the chain brake (fig.30).
that there is enough fuel in the tank.
8.7 USING THE CHAIN SAW WITH ONE HAND
- Do not use the chain saw for tree service with
one hand:
- in an unstable position;
- when cutting branches of small diameter parts
of the tree and at the top of trees.
STOP
- The chain saw for tree service can be used
with one hand in the following circum-
stances:
1) when no other working position suitable for
working with 2 hands can be found;
2) when ensuring a working position with the left
C
hand is required;
3) when the operator needs to lean forward a lot
I
(see fig.17).
The operator must never:
1) Cut branches using the nose of the guide bar
subject to kickback (see chapter 2 paragraph
A.19);
USING ANGLE
AFFECTED BY
THE DANGER OF
KICKBACK
2) hold and cut the part of the branch to be re-
moved;
Before suspending the chain saw
on the rope (with engine on), al-
Before carrying out a critical cut,
the operator must always check
90°
37