Reversing The Door - Polar DM071 Manual De Instrucciones

UK
Installation
Note: If the unit has not been stored or moved in an upright position, let it stand
upright for approximately 12 hours before operation. If in doubt allow to stand.
1. Remove the appliance from the packaging and the protective film from all surfaces.
2. Avoid positioning the cooler in direct sunlight or damp areas.
3. Maintain a distance of 20cm (7 inches) between the unit and walls or other objects for ventilation.
NEVER LOCATE NEXT TO OR NEAR A HEAT SOURCE.
4. If necessary, adjust the screw legs of the cooler to make it level.
WARNING: When positioning the appliance, ensure the supply cord is not
trapped or damaged.
WARNING: Do not locate multiple portable socket-outlets or portable power
supplies at the rear of the appliance.

Reversing the Door

Depending on the location of the appliance, it may be necessary to change the direction the door of the
cooler opens by changing the side of the door handle.
To reverse the door handle:
1. Ensure the appliance is disconnected
from the power supply.
2. Tilt the appliance back slightly and prop
it securely. The appliance must not be
tipped back by more than 45 degrees.
3. Unscrew the door hinge screws on the
base of the door and remove the Hinge.
4. Open the door slightly and remove the
door in a downwards direction.
5. Remove the plastic screw cover from
the top of the cooler by levering it off
with a small screwdriver.
6. Unscrew and remove the hinge from the
top of the appliance.
7. Screw the reversed door frame Hinge to
the opposite side of the appliance and
reattach the screw cover.
8. Fit the door into place by locating the
upper Hinge first then closing the door.
9. Reattach the Bottom hinge onto the
opposite side of the door.
10. The appliance can now be lowered into
position.
Operation
The controller is located at the rear of the appliance.
The thermostat is graded from 0 (warm) to 5 (cold).
4
DM071_ML_A5_v3_20190619.indb 4
Screw cover Top hinge
Bottom hinge
2019/6/19 15:01