Lock/Unlock The Doors; Fitting The Shelves & Floor Guards - Polar UA025 Manual De Instrucciones

EN
Installation
Note: Not for use in vans or trailers, food
trucks or similar vehicles.
Note: If the unit has not been stored or
moved in an upright position, let it stand
upright for approximately 12 hours before
operation. If in doubt allow to stand.
1. Remove the appliance from the packaging.
Make sure that all protective plastic film and
coatings are thoroughly removed from all
surfaces.
2. To optimize performance and longevity, ensure
a minimum clearance of 2.5cm is maintained
between the unit and walls and other objects,
with a minimum 20cm clearance on the top.
NEVER LOCATE NEXT TO A HEAT SOURCE.
Note: Before using the appliance for the
first time, clean the shelves and interior
with soapy water then dry well.
3. Set the brakes on the castors to keep the
appliance in position.
Removing the Compressor Safety
Band
• The compressor is located on the top of the
appliance, and sits on rubber washers. Under
normal operating conditions the compressor is
allowed to vibrate.
• To avoid damage through excessive motion
during transit, a stainless steel safety band is
placed over the compressor and screwed into
the top of the appliance.
• This safety band and the two screws fixing it
to the appliance must be removed before the
appliance is turned on.
4
UA025_ML_A5_v1_20221121.indb 4 UA025_ML_A5_v1_20221121.indb 4

Lock/Unlock the Doors

A lock is fitted to the doors to ensure foodstuffs
are kept secure within your POLAR appliance.
Use the keys provided to lock/unlock the doors.
• There is a catch on the top of the lower door.
When it is rotated to the left position, only the
upper door is locked.
Catch on the lower door
• To lock both doors, rotate the catch to the right
position, then close the lower door and upper
door consecutively.
Catch on the lower door
Fitting the Shelves & Floor Guards
1. Place one set of shelf guides on either side of
the cabinet at the desired height.
2. Slide the shelf into place.
3. Repeat for the remaining shelves.
4. Place the floor guards on the floor of the
cabinet, ensuring the flat side is clear of the
floor.
Compressor
Safety Band
Note: This is vital for ensuring correct
drainage of condensation. If this is done
incorrectly, your appliance may get wet
and/or freeze on the bottom. In the event
Compressor
of a complaint, this is not covered by the
Screws
warranty.
2022/11/21 16:55 2022/11/21 16:55